11.2.2 General settings

Figure 1.

  1. Tramlining ON/ OFF

  2. If the machine is equipped with WideLining, this has to be marked. The output will then not be switched off for the row units that indicate tramlines and the row units will move laterally instead.

  3. Task Control ON/OFF

  4. Manual feed rate

Figure 2.

  1. Fertiliser output Off/Normal/FH (front hopper)

  2. Output rate fertiliser AV/3m³/ 5m³ 1

  3. Periodic auger, fertiliser ON/OFF

  4. Agitator FH

    When selecting fertiliser for the FH, the Agitator setting is displayed for the front hopper. The selection for this setting is OFF/ON/AUTOMATIC 2

  5. Micro granulate ON/OFF

  6. BioDrill ON/OFF

  7. Agitator BioDrill ON/OFF/AUTOMATIC

    ON: Electric motor/ hydraulic valve is always running/open

    OFF: Electric motor/ hydraulic valve is never running/closed

    AUTOMATIC: Electric motor/hydraulic valve running/open when any of the BioDrill motors are running

  8. BioDrill motor type agitator HYDRAULIC/ELECTRIC

  9. BioDrill agitator speed. Only selectable with electric motor type.

  10. Liquid fertiliser ON/OFF

Figure 3.

  1. Speed source

    • Radar on the machine or via ISO11786 connector.

    • Ground speed (No Slip) via ISO11783 connector. 3

    • Wheel-based speed (Slip) via ISO11783 connector. 45

  2. Height source, machine detectors

    • Machine sensors

    • The height of the 3-point linkage via ISO11786 connector. 6

    • The height of the 3-point linkage via ISO11783 connector. 7

  3. Number of row units on the machine

  4. Distance between the row units on the machine

  5. Seed output percentage is adjusted by pressing the +/- buttons

  6. Fertiliser output percentage is adjusted by pressing the +/- buttons

  7. Micro granulate output percentage is adjusted by pressing the +/- buttons.

  8. BioDrill percentage is adjusted by pressing the +/- buttons

  9. Liquid fertiliser output percentage is adjusted by pressing the +/- buttons

  10. Row unit pressure in kilos is adjusted by pressing the +/- buttons

1 only TPL and Central Fill
2 only TPL
3 Note that when selecting a speed from ISO11783, it is a requirement that the tractor’s terminal is able to support the selected speed source.
4 Note that when selecting a speed from ISO11783, it is a requirement that the tractor’s terminal is able to support the selected speed source.
5 Note that wheel-based speed can lead to reduced accuracy, depending on the amount of slippage that the tractor experiences when drilling.
6 Note that when selecting a height source from ISO11786/11783 connector, it is a requirement that the tractor is able to support this. Only selectable on TPR, TPT and TPV.
7 Note that when selecting a height source from ISO11786/11783 connector, it is a requirement that the tractor is able to support this. Only selectable on TPR, TPT and TPV.