6.2.1 Adapting the sensors to the seed feed

  1. The ports on the distributor head connected to the tramlining engines show a green tractor track.

  2. The ports can be changed in one of the following ways:

    1. Press the port you want to change.

    2. Press the port you want to replace.

    or:

    1. Press the port you want to change.

    2. Press the port again.

    3. A question mark appears in a circle, indicating that the detector is not mapped. It is possible to create multiple unmapped rows at the same time (proceed to step 2.e)

    4. Press the row to be changed with the unmapped port.

    5. Press the question mark to display unmapped ports with missing rows. See Figure 3 and perform step 5

    Figure 1.

  3. Press Apply to save.

  4. One port is unmapped. Press OK to continue.

    Figure 2.

  5. Select the port for the missing row. Click the remaining question mark and select from the available rows.

    Figure 3.

  6. Press Apply to save.

  7. SeedEye is automatically re-registered when the ports are updated by pressing the Apply button.

  8. If you press the SeedEye button at the top, the settings change to the last approved configuration. When you use this button, you are going back to the previous menu.

  9. To factory reset, set the row output to OFF (G); see Figure 2.