6.2 General settings

Important

For daily use no settings need to be entered in this menu.

Figure 1.

  1. Speed for manual feed rate (km/h). Adapts the manual feed speed to the intended driving speed. If the expected driving speed is e.g. 7 km/h, the speed 7 km/h must be selected for manual feed.

  2. Seed hopper modes.

    1. Seed – Fertiliser

    2. Seed - Seed

    Specify whether the machine will be used for combination drilling (a) or whether the whole seed hopper will be used for seed (b).

    (Applies to ST 600-900C only. When seed/seed is selected, fertiliser will be hidden in the UI).

  3. K-value. Correction of an average deviation between the selected output quantity of fertiliser and the actual feed rate. (Applies to ST 600-900C only).

    Example: Set amount: 360 kg/ha. Actual amount fed out: 400 kg/ha. 360/400=0.9. Change the K value to 0.9.

  4. Fan shut-off ON/OFF. (Applies to STC only).

  5. External Control is a GPS-based help function for use in the field. See 6.4 Task Control.

  6. Increased row spacing ON/OFF. Can switch off even or odd rows. Only visible for fully equipped CAN bus Flexhead. When “Increased row spacing” is activated, tramlining will be switched off, and half machine shut-off will be disabled for ST400 and ST600InLine. The sown amount will not be reduced.

  7. Shut-off. Even or odd rows.

Figure 2.

  1. Row output, seed

  2. Row output, fertiliser

  1. If a custom setting for detectors for seed/fertiliser row output(G/H) is set, it can be factory reset by turning it off (off).

  2. Seed/Fertiliser row output (G/H), see 6.2.1 Adapting the sensors to the seed feed.