11.2.6 Tramlining

Figure 1.

This screen is intended for calculation of tramlining.

The following values need to be entered:

  1. Total width of the equipment

  2. Distance between the set of wheels

  3. Width of the wheels (safe clearance of the plants can be achieved by entering a higher value here.

    Example: the wheel width is 500 mm, but additional protection of 50 mm for the plant is desired – so 600 mm should be entered).

  4. Also indicate which direction the tractor will turn after the first bout.

  5. Tramlining Compensation is a function that allows you to vary the application rate using the tramline program. By entering a percentage in (E) all rows adjacent to a tramlining row will receive an increased application, according to the percentage entered

  6. Number of bouts

  7. Number of overlaps

  8. Starts calculation of rows and overlaps.