10.12 Wing folding
Wing folding should be done while the machine is stationary on a flat surface.
Bleed the system to line up front tool and coulters.
Select 
in field (C) on the home screen, see Figure 1 to enable the wing fold function.
Start
Press Start to start the wing folding action.
Figure 1.
Lowering
Lower front tools and seed coulters to the correct position by using the yellow circuit.
Figure 2.
Raising
Figure 3.
Extending to working position
Extend the machine completely by using the red circuit. Hold the hydraulic lever in the lowering position until the folding cylinder has been completely extended and until the weight transfer cylinder’s piston rod has moved out to half its length.
Figure 4.
Confirm extension
Press the green button on the screen to confirm that the wings are fully extended, that the weight transfer cylinder’s piston rod is halfway out, and that the accumulator is fully pressurised.
Figure 5.
Raising to align the machine
Lift front tool and seed drill unit to full lift. Hold for a few seconds in order to align the system. This is necessary to ensure that the centre section and wing sections do not have different cultivation depths.
Figure 6.
Retracting to transport position
Retract the machine completely by using the red circuit. Hold down the hydraulic switch in raise mode until the folding cylinder has retracted completely.
Figure 7.
Confirm wing folding
Press the green button on the screen to confirm that the wings are fully retracted, that the wing folding cylinder is completely closed.
Figure 8.
Raising
Lift front tool and the middle section of seed drill unit to full lift.
Figure 9.
Finished
Figure 10.