20 Release notes

Version

Information

4.0.6

Improvements

  • Added language option for portuguese. 

Bug fixes

  • Correction of bug where some TC settings made toggling of row states on dashboard impossible.

  • When configuring FH fertilizer, the CAN interface now automatically starts. 

  • Correction of fertilizer motor status on info-page. 

4.0.5

Bug fixes

  • Correction of fertiliser coulter pressure buttons.

4.0.4

Improvements

  • Support for up to 32 rows on TPL with Liquid Fertilizer

  • Possibility to configure if tramline rows shall be counted as seeded (which also replaces the setting for if TC shall paint the tramline rows shall as covered or not)

Bug fixes

  • Ensure that the seed spacing and seed rate are consistent after factory configuration has set the row distance.

  • A red bar on the skips/doubles graph could be shown for a short while just after seeding was started. This has now been corrected so that the indication is not shown until a measured value for seeds/seconds should be available after start of motor

  • The On/Off/Auto setting for agitators had swapped function for On and Off, which now has been corrected.

  • TPL System Pressure display on dashboard could show wrong value on some machines depending on how the machine height sensor has been configured. This has now been corrected so that the input for system pressure is not affected by the machine height setting.

  • The fertilizer prefill button on VT was hidden in previous release but is now shown again.

  • The fertilizer prefill button on VT was hidden in previous release but is now shown again.

4.0.3

  • Support for update of seeded/ driven area from e-tech 2.0

4.0.2

  • Initial release on ACU6.

  • Release on GW100 for the WS9 Liquid Fertilizer machines (in field).

4.0.1

  • Initial release. Added support for Liquid fertilizer and a new ISOBUS framework